Dai ly
Startu
p/Sh
utdown
Automatic
Startup/Sh
utdown
With the seven-day
clock and
auto-energize
pump
features on, the following
occur:
1.
The heaters turn on automatically and the
pump
stafts when the tank reaches either the READY
condition or a temperature
you
have selected.
2. The heaters turn off automatically and the system
shuts itself
down.
ManualStartup
1. Check the adhesive level. lf the level is below
50%,
add adhesive to the tank. Fillto within
25 mm
(1
inch) of the
tank top.
25 mm
5Oo/"
2. Close the lid immediately to
prevent
contamination
of the adhesive.
3.
lf the POWER switch is off, turn it on
4. Prepare
each
gun
in
your
system for operation as
follows:
.
Air-operated
guns:
turn on the operating air.
.
Handguns:
unlock the trigger.
.
Electric
guns:
turn
on the
gun
driver.
5.
Press the HEATERS key. The HEATERS light will
turn on
and the
unit will
begin
to heat.
,*r=*@:pf
6.
Turn
on the
pump
air
pressure
and adjust it to the
setting that works best for
your
system.
7.
. Check the temperature setting for each heated
zone.
8. When the READY light turns on,
press
the PUMP
key.
WARNING: When
the tank
lid is open, hot melt
vapors may be released. Vent the application
area or wedr
a
respirator for
protection
from
vapors.
9. Check
the
adhesive
level
periodically.
Refill the
tank before
the
level
drops below 50%.
ManualShutdown
1. Press the PUMP key. The PUMP light will turn off
and
the
pump
willstop.
PUMP
E
e
o
2.
Place containers beneath all
guns
and trigger the
guns
to
relieve
hydraulic
pressure.
3.
Use
one of the following methods
to
prevent
accidental
gun
triggering:
o
Air-operated
guns:
reduce air
pressure
to 0
.
Handguns:
place
the
trigger safety
in the
locked
position.
o
Electric
guns:
turn off the
gun
driver.
A
A
+
3
WARNING: Never hang
a handgun by
its
trigger. The
gun
can accidentally discharge
material,
causing burns.
4. Press
the
HEATERS
key. The HEATERS
light will
turn off.
,*r.rs6E
o
.:
l
lssued 4/98
2297nC
To Next Page
Loading...
