9
MEG® II Airless Spray Guns with 10 ft Cable
© 2021 Nordson Corporation
1602990-12
Pressure Transducers
When the MEG II gun is installed as part of a iTrax spray monitor system, install the
Pressure Transducer on page 31 for transducer ordering information.
Refer to the pressure transducer instruction sheet included with this manual for more
installation instructions.
See Figure 2.
pressure transducer. The port on either side of the manifold can be used. Tighten the
transducer securely.
CO-Plate
When the MEG II gun is installed as part of a iTrax spray monitor system, install a CO-
plate in the gun manifold to produce a controlled pressure drop when the gun is spraying.
Refer to the CO-Plate Selection Chart on page 32 for CO-plate ordering information.
See Figure 2.
the manifold. Tighten the CO-plate securely.
To Next Page
Loading...
