16
MEG® II Airless Spray Guns with 10 ft Cable
© 2021 Nordson Corporation
1602990-12
Upper Manifold O-Ring Replacement
WARNING:
performing the following procedure. Failure to do so could result in personal injury.
Have the following on hand:
• replacement O-rings
•
NOTE: Inspect all O-rings and replace any that are damaged. Lubricate all O-rings with
petroleum jelly before assembly. The soft goods service kit listed in Parts includes all
O-rings used in the MEG gun, or they can be ordered separately.
Removal
See Figure 6.
1. Make sure all pressure is relieved and electrical power is removed from the system.
2. Remove the MEG II gun from the spray machine.
3.
4. Disconnect the gun wiring from the terminal block and fuse holder, if used.
5.
6.
7.
8.
NOTE:
manifold. If you install them from the back, you will have to pull the manifold wires all the
way out of the conduit and through the manifold lock nut and lower manifold.
9.
10.
Installation
See Figure 6.
1.
2.
manifold shoulder.
NOTE: If you pulled the upper manifold wires out of the conduit and lower manifold,
To Next Page
Loading...
Need help?
General
