5
MEG® II Airless Spray Guns with 10 ft Cable
© 2021 Nordson Corporation
1602990-12
Description
See Figure 1.
This manual covers the MEG II reduced cavity and extended spray guns with 10 ft (304
solvent-based coatings to the interior surfaces of metal cans.
NOTE: The MEG II guns are approved for solvent-based materials when using approved
drivers. To meet approvals, the fuses and fuse holders supplied with the MEG II guns
must be installed.
The MEG II guns can be used with the iTrax
®
system control and monitoring.
The MEG II guns feature:
• special internal coil and armature assembly for cooler gun operation
•
• online-replaceable ball and seat
•
•
Two or three MEG II guns can be positioned in a spray pocket for zone-spray
applications. The MEG II guns can be installed on existing spray machine mounting
plates that use these Nordson guns:
• A20A
• A10A
• A14A
Refer to Specications on page 33 for technical data and label information.
II
2 G
Extended Tip Version
Reduced Cavity Version
Figure 1
1. Gun Module
2. Manifold
3.
4. Electrical conduit and
cable
To Next Page
Loading...
Need help?
General
