Comprehensive Manual78
© 2018 Nortek AS
3.3.7.1 Midlife Electronics
Midlife electronics change the power levels with a simple command in the terminal emulator:
3.3.7.2 Pre-midlife Electronics
You can change the output voltage level that is supplied to external sensors. This is typically needed
if an external analog sensor (e.g. OBS) operates in a specific voltage range and the raw battery
power does not fall within this range. The default output voltage level is RAW (battery or external
adapter). This can be changed to +5V or to +12V by changing the position of a 0-W resistor. The
three resistor positions share one pad so the modification should be straightforward.
To Next Page
Loading...
