Nortel 1220 - Using the Callers List

Operating your IP Phone 1220
84
• “Using the Personal Directory” on page 94
• “Using Predial” on page 94
• “Using AutoDial” on page 95
• “Using Ring Again” on page 97
• “Using Last Number Redial” on page 98
• “Using Speed Call” on page 99
• “Using System Speed Call” on page 100
• “Using HotLine” on page 100
• “Using Intercom Calling” on page 101
Using the Callers List
The Callers List logs all incoming calls. The Callers List can store up to
100 entries. When the list is full, the oldest entry is overwritten. Use the
Callers List to review missed calls and make a call if required. The Callers
List contains the following components:
• the caller’s last and first name (if available)
• the DN of the caller
• the time and date of the call
• the number of times the caller called
Callers List entries are sorted on call arrival time.
The format of names in the Callers List depends on the configuration of
Preferred Name Match. The Calling Party Name Display (CPND) appears
according to the configuration settings on your phone if Preferred Name
Match is active on your phone. If Preferred Name Match is off, the CPND
appears according to the system configuration.
To access the Callers List, press the Directory key, and select Callers
List. If password control is enabled, you must enter your SCPW at the
prompt.