Nortel 1230 - Overriding a Busy Signal

Operating your IP Phone 1230
143
• “Using Enhanced Override” on page 145
Overriding a busy signal
Use the Override feature to override a busy signal and interrupt another
call.
Using Forced Camp-on feature
Use the Forced Camp-on feature to automatically call a busy telephone
(internal or external) immediately after the telephone disconnects from
the current call.
1. Dial a number.
You receive a busy tone.
2. Press the EnhOvr key.
or
Enter the Override FFC.
The person in the targeted call receives
a tone for approximately 1 second. After
the Override feature connects you to the
call, a short tone repeats every 16
seconds.
3. To terminate the call, press the
Goodbye key.
EnhOvr
or
(Goodbye)