How to troubleshoot a NorthStar 1201 with no display?
If your NorthStar Monitor isn't displaying anything, start by checking if the display is receiving power by measuring the voltage on the power cord. Next, ensure that the Data/Video source is powered up and running. Finally, test the Data/Video source with another display to rule out issues with the source itself.
What to do if the image on my NorthStar 1201 is noisy?
If the image on your NorthStar Monitor appears noisy, check the wiring to ensure there are no loose or corroded connectors. You can also check the image source by momentarily connecting another display to the source. For the 1202 model, consider adjusting the phase as described on page 12.
How to restore factory defaults on NorthStar 1201 Monitor?
To restore factory defaults on your NorthStar Monitor: for the 1201 model, use the Auto Setup menu function in the Setup Menu. On the 1202 model, use the Restore Factory Defaults line on the Utilities icon in the Setup Menu.
Why does my NorthStar 1201 have vertical hum bars?
Thin vertical lines, also known as vertical hum bars, are most likely a result of subtle timing differences between the image source and the display. For the 1201, try adjusting the tuning as described on page 10. You might also try decreasing the brightness setting. If you have the 1202, adjust the phase as described on page 12.
What to do if the picture on my NorthStar 1201 Monitor is snowy?
If your NorthStar Monitor's picture appears snowy, check the Data/Video source using another display. Also, inspect the cable routing of both video and data cables.
Why is the picture too narrow for the screen on my NorthStar 1202 Monitor?
The 1202 display source you are using is SXGA. See "Graphic Scaling Mode Setup" on page 14 for more information about why this occurs.
How to center image on NorthStar Monitor screen?
Introduces the buttons and controls on the display's front panel.
Details the function of the POWER, Brightness, DATA, and VIDEO buttons.
Explains the RED and HI/LO buttons for special viewing modes.
Describes the function of the MENU button for settings and adjustments.
Describes how to turn the display and vBox on/off.
Details how to adjust screen brightness using up/down arrows.
Explains DATA button for selecting VGA input and menu navigation.
Explains VIDEO button for selecting NTSC/PAL input and menu navigation.
Details the RED mode for data images, requiring the vBox.
Explains HI/LO mode for day/night viewing, requiring the vBox.
Describes MENU button for picture quality and PIP settings (1202).
Provides guidance on using the Setup Menu and notes for 1201/1202 models.
Explains how to navigate and adjust settings in the 1201 Setup Menu.
Details how to turn PIP on/off, adjust size, position, and advanced settings.
Details the 3-pin circular power connector and voltage/current requirements.
Explains the 18-pin vBox connector and its compatibility warning.
Describes the 15-pin VGA connector for data input and its warning.
Provides critical safety warnings regarding power, fuses, and wiring.
Warns against water entering the rear of the display, causing failure.
Details how to connect the vBox to the display using the supplied cable.
Explains how to connect data sources to the vBox's data ports.
Explains how to connect video sources to the vBox's video ports.
Explains how the 1202 uses PIP with the vBox for multiple video/data views.
Provides guidelines for testing the display and vBox connections after installation.
Explains how to test auxiliary inputs and night modes when a vBox is used.
A table listing common symptoms and their potential causes.
Explains the process for obtaining factory service and authorized repairs.
Details the procedure for returning a unit for warranty repair, including RMA.
Outlines the two-year warranty coverage for defects in materials and workmanship.
Lists conditions that void the warranty, like improper installation or damage.
To Next Page
General