BACnet GW-3 Configuration and Operation BACnet GW-3 Operation
40 BACnet Gateway-3 Installation and Operation Manual - P/N: 53372:Rev: A 5/6/09
3.5 BACnet GW-3 Operation
3.5.1 About BACnet GW-3 Start Up
On start up, the gateway auto discovers devices (panels and annunciators.) and objects (detectors,
modules, panels circuits, zones, loops, battery, AC Power, Ground, etc....) on NFN network it is
connected to and creates BACnet objects according to your configuration.
Devices and objects are given names Below are some format examples:
An AFP1010 as node 142: .Name = 142AFP1010 (BACnet Device Object)
An NFS640 as node 234: .Name = 234_NFS640 (BACnet Device Object)
(Detector) Loop 5, Detector 83: L005D083 (BACnet Life Safety Point or Multi-state Input Object)
(Zone) Zone 134: ZONE0134 (BACnet Life Safety Zone or Multi-state Input Object)
Any Node, Loop 5, Control Module 12: L005C012 (BACnet Binary Output Object)
An AM2020 as node 120: .Name = 120_AM2020 (_ denotes spaces) (BACnet Device Object)
An NCM as node 11 connected to BACnet GW: .Name = 011_ _ _ BACGW (BACnet Device Object)
(Module) Loop 9, Module 120: L009M120 (BACnet Life Safety Point or Multi-state Input Object)
(Zone) Zone 1003: ZONE1003 (BACnet Life Safety Zone or Multi-state Input Object)
(Panel Internal Devices)--LOOP 8, LOOP10, BATTERY, ANNUN021, ACPOWER, PANEL (BACnet Life Safety Point or
Multi-state Input Object)
To Next Page
Loading...
Need help?
General
