Environmental Requirements NOTIFIER® BACnet Gateway-3 Features
9BACnet Gateway-3 Installation and Operation Manual - P/N: 53372:Rev: A 5/6/09
• CAN/ULC-S559-04—Equipment for Fire Signal Receiving Centres and Systems, First
Edition
1.3.2 Installation
This product is intended to be installed in accordance with the following regulatory agencies.
Local
• AHJ—Authority Having Jurisdiction
National Fire Protection Association
• NFPA 70—National Electrical Code
• NFPA 72—National Fire Alarm Code
• NFPA 101—Life Safety Code
Underwriters Laboratories
• UL-1076—In certified applications, the unit shall be installed in accordance with Proprietary
Burglar Alarm Units and Systems, Fifth Edition
Underwriters Laboratories Canada
• C22.1–98—Canadian Electrical Code, Part I (Twentieth Edition), Safety Standard for
Electrical Installation
• CAN/ULC-S524-06—Standard for the installation of Fire Alarm Systems, Fifth Edition
• CAN/ULC-S561-03—Installation and Services for Fire Signal Receiving Centres and
Systems, First Edition
About Ethernet Network Installations
“Listed for the purpose” has been formally interpreted by NFPA (Formal Interpretation 72-99-1)
for equipment on packet switched networks as being listed to the requirements applicable to
general purpose communications network equipment.
For ULC applications, the Internet cannot be used for either primary or ancillary functionality.
“Listed for the purpose” has been formally interpreted by NFPA (Formal Interpretation 72-99-1)
for equipment on packet switched networks as being listed to the requirements applicable to
general purpose communications network equipment.
For ULC applications, the Internet cannot be used for either primary or ancillary functionality.
1.4 Environmental Requirements
This product must be installed in the following environmental conditions:
• Temperature range of 0°C to 49°C (32°F - 120°F).
• 93% humidity non-condensing at 30°C (86°F).
The contents of this manual are important and must be kept in close proximity of the hardware. If
building ownership is changed, this manual and all other testing and maintenance information must
also be passed to the current owner of the facility. A copy of this manual was shipped with the
equipment and is also available from the manufacturer.
!
WARNING: Installation
Improper installation, maintenance, and lack of routine testing could result in system malfunction.
NOTE: Refer to Appendix A, “PIC Statement”, on page 41 for the BACnet PIC statement.
To Next Page
Loading...
Need help?
General
