CHANGE LEVEL 1 PASSWORD
Pressing
ENTER
, it will be possible to select a new level 1 Password.
Use
CURSOR
keys, to select the level number and press ENTER
to confirm.
The programmable Password may be made up of 1 to 14 figures
(numbers)
To enter a figure:
•
Select the desired number, using the CURSOR keys
•
Press ENTER
To escape the programming, press ENTER a second time.
If you do not want to change the programming, press ESC.
TEST MENU - LEVEL 2 -
Press ENTER o have access to the test functions, and the display will show:
Press the
DOWNWARDS CURSOR
Key.
Level 2 Password will be required. Enter it.
The display will show the first availabe function in TEST mode:
Use cursor keys to display the desired function, choosing among:
•
Display Line Status
•
Change Controls - Enable/Disable status
•
Select Zone for Walk Test Mode
•
Display Firmware Revision
•
Change Level 2 Password
Press
ESC
to go back to the main screen.
DISPLAY LINE STATUS
On the display will appear the line status in the following form:
Display will follow line status in real time. This function may be usedas generic check after installing the control panel or
just before performing the Walk Test.
Press
ESC
to leave this function.
Anyway, the control panel will escape this function after a maximum programmable time-out (see SYSTEM TIME DELAY)
CFP-600-Prog-2.VP Installation and Operating Manual Page 7
Doc. M-131.1-CFP600-ENG Rev. B.1 NOTIFIER ITALIA
USER MODE | A08
CHANGE PASSW. | G08
| D00
| E00
CHANGE PASSW. | A08
LEV. PASSW. | G08
| D00
| E00
CHANGE PASSW. | A08
LEV. PASSW. | G08
1 0001 | D00
| E00
:User Mode | A08
:Test Mode | G08
:Configuration | D00
:Exit | E00
LEV. 2 PASSW. | A08
| G08
| D00
| E00
TEST MODE | A08
LINE STATUS | G08
| D00
| E00
•
N= not Alarm
•
A= Alarm
•
SH.C= Short circuit
•
W.CUT= Wire cut
•
E= Enabled
•
D= Disabled
•
E= Excluded
•
T=Test
NE NE NE NE
NE NE NE NE
NE NE NE NE
Line nr. 1
Line nr. 5
Line nr. 9
Line nr. 4
Line nr. 8
Line nr. 12
To Next Page
Loading...
