Notifier CFP-600-E - Logic and Service Configuration; Programming the CBE Equations; Change Service Enabling Status

CHANGE LEVEL 2 PASSWORD
By pressing ENTER , it is possible to select the level whose password has to be changed.
Use CURSOR keys, to select the level number, then press ENTER
to confirm.
The programmable password may be made up of 1 to 4 figures (num-
bers).
To Enter a figure:
•
Select the desired number with cursor keys
•
Press ENTER
To accomplish the programming press ENTER a second
time.
If you do not want to modify the programming, press ESC
CONFIGURATION MENU - LEVEL 4
Press ENTER to go into Configuration Functions and the display will show:
Press RESET key.
Level 4 Password will be required.
Enter the Password by using CURSOR keys.
On the display will appear the first available function in the
CONFIGURATION mode.
Use cursor keys to display the desired function, choosing among:
• CHANGE ZONES - INCLUDE/EXCLUDE STATUS
• PROGRAMMING THE CBE EQUATION
•
CHANGE SERVICE ENABLING STATUS
•
CHANGE ZONE PARAMETERS
•
CHANGE VERIFICATION TIMES
•
PROGRAMMING THE RELAY MAPPING
•
ENABLING THE RELAY SIGNAL SILENCE
•
CHANGE ZONE DESCRIPTION
•
CHANGE SYSTEM TIME DELAY
•
CHANGE ALARM TIME PARAMETERS
•
PROGRAMMING THE ALARM CONTROL MODULATION
•
PROGRAMMING THE RELEASE ZONE MAPPING
•
CHANGE RELEASE TIME
•
SELECT EVENT TYPE FOR HISTORICAL LOG
•
PROGRAMMING THE SYSTEM NAME
•
CLEARING THE CONTROL PANEL MEMORY
•
CHANGE LANGUAGE DISPLAY
•
CHANGE ALL LEVEL PASSWORDS
Press ESC to go back to the main screen.
CFP-600-Prog-2.VP Installation and Operating Manual Page 9
Doc. M-131.1-CFP600-ENG Rev. B.1 NOTIFIER ITALIA
TEST MODE | A08
MODIFY PASSW. | G08
| D00
| E00
MODIFY PASSW. | A08
LEV. PASSW._|G08
| D00
| E00
MODIFY PASSW. | A08
LEV.2 PASSW._ | G08
2 0002 | D00
| E00
:User Mode | A08
:Test Mode | G08
:Configuration | D00
:Exit | E00
LEV.4 PASSW. | A08
| G00
| D00
| E00
CONFIGURAT. | A08
INC./EXC.ZONES| G00
| D00
| E00