Notifier CFP-600-E User Manual

CHANGE ZONES - ENABLE/DISABLE STATUS
By using CURSOR KEYS , enter the desired zone number.
By pressing ENTER key, the current status of the selected zone will be
displayed.
Press ENTER to Disable or Enable.
If you do not want to change the zone status, press ESC .
»
NOTE: A)
CHANGE DAY-NIGHT MODE
By pressing ENTER , the display will show the control panel status
To change it, press ENTER .
•
NIGHT= Day/Night LED= Turned OFF
•
DAY= Day/Night LED = Turned ON
If you do not want to change the control panel status, press ESC .
DISPLAY HISTORICAL LOG
Press ENTER to display the Historical Log Function.
Use CURSOR KEYS to display the events
Press ESC to leave the Historicl Log Function
»
NOTE: Historical Log may store maximum 50 events.
To display the Historical Log, enter the Level 2 PASSWORD.
CFP-600-Prog-1.VP Installation and Operating Manual Page 5
Doc. M-131.1-CFP600-ENG Rev. B.1 NOTIFIER ITALIA
USER MODE |A08
ENA./DIS.ZONE |G08
|D00
|E00
ENA./DIS.ZONE |A08
Z. |G08
|D00
|E00
ENA./DIS.ZONE |A08
Z. 01 NORMAL |G08
|D00
Modify Exit |E00
Zone Status Detector Alarms Detector Troubles
Enabled YES YES
Disabled NO YES
Excluded NO NO
B) if a zone is DISABLED, it detects only troubles.
(See config. Menu - Lev.4 about “Exclusion function”)
USER MODE |A08
DAY-NIGHT |G08
|D00
|E00
|A08
>NIGHT< |G08
|D00
Modify Exit |E00
USER MODE |A08
HISTORICAL LOG |G08
|D00
|E00
HISTORICAL LOG |A08
01: 14-04 17:31|G08
Z.01 ALARM |D00
HIST. LOG |E00
Date
Event nr.
Zone nr.
HOURS-MINUTES
Event
Programmable
Label mapped
to the zone

Notifier CFP-600-E Specifications

General

Brand	Notifier
Model	CFP-600-E
Category	Control Panel
Language	English