14
Preparation for Use
NOTICE
● Use of a barrier sleeve with a width of 35 mm or greater is recommended�
2
Align the mark of the motor handpiece
cord plug with the
mark of the motor
handpiece connector socket and insert the
plug until it locks�
Disconnecting
Hold the plug and pull it out� Do not twist in any direction�
CAUTION
● Be sure that there is no damage on the new barrier film and barrier sleeve before use� Do not use
it if it is damaged�
● For details of the barrier sleeve and barrier film, see the operation manual issued by manufacturer�
4 – 5
Connecting and disconnecting the contra angle head
Connecting
1
Align the positioning pins of the contra angle
head with the positioning slots of the motor
handpiece and insert the head until they
click� The contra angle head could be
connected with the motor handpiece at 6
adjustable head positions�
2
Attach a disposable barrier sleeve to the
contra angle head and secure the end of the
barrier sleeve with the barrier film�
To Next Page
Loading...
