NTI TRINITY Ts80 - Page 61

Ts Series Installation and Operation Instructions │Trinity Ts
61
Table 16-3 Hold and Lockout Codes
Code Description Note
190 Invalid interrupted air switch enable setting Lockout
191 Invalid interrupted air switch start check enable setting Lockout
192 Invalid Igniter on during setting Lockout
193 Invalid Ignite failure delay setting Lockout
194 Invalid Ignite failure response setting Lockout
195 Invalid Ignite failure retries setting Lockout
196 Invalid Ignition source setting Lockout
197 Invalid Interlock open response setting Lockout
198 Invalid Interlock start check setting Lockout
199 Invalid LCI enable setting Lockout
200 Invalid light off rate setting Lockout
201 Invalid Light off rate proving setting Lockout
202 Invalid Main Flame Establishing Period time setting Lockout
203 Invalid MFEP flame failure response setting Lockout
204 Invalid NTC sensor type setting Lockout
205 Invalid Outlet high limit response setting Lockout
206 Invalid Pilot Flame Establishing Period setting Lockout
207 Invalid PII enable setting Lockout
208 Invalid pilot test hold setting Lockout
209 Invalid Pilot type setting Lockout
210 Invalid Post-purge time setting Lockout
211 Invalid Power up with lockout setting Lockout
212 Invalid Pre-ignition time setting Lockout
213 Invalid Pre-purge rate setting Lockout
214 Invalid Pre-purge time setting Lockout
215 Invalid Purge rate proving setting Lockout
216 Invalid Run flame failure response setting Lockout
217 Invalid Run stabilization time setting Lockout
218 Invalid Stack limit enable setting Lockout
219 Invalid Stack limit response setting Lockout
220 Unconfigured Delta T limit set point setting Lockout
221 Unconfigured DHW high limit set point setting Lockout
222 Unconfigured Outlet high limit set point setting Lockout
223 Unconfigured Stack limit set point setting Lockout
224 Invalid DHW demand source setting Lockout
225 Invalid Flame threshold setting Lockout
226 Invalid Outlet high limit set point setting Lockout
227 Invalid DHW high limit set point setting Lockout
228 Invalid Stack limit set point setting Lockout
229 Invalid Modulation output setting Lockout
230 Invalid CH demand source setting Lockout
231 Invalid Delta T limit delay setting Lockout
232 Invalid Pressure sensor type setting Lockout
233 Invalid IAS closed response setting Lockout
234 Invalid Outlet high limit enable setting Lockout
235 Invalid Outlet connector type setting Lockout
236 Invalid Inlet connector type setting Lockout
237 Invalid DHW connector type setting Lockout
238 Invalid Stack connector type setting Lockout