Vmax I&O Manual │ Parts List
Tee, Brass, ¾ x ½ x ¾”, VM110P
Tee, Brass, 1 x ½ x 1”, VM110
Hose Clamp, 9/16 to 1-1/16”
Flue Outlet Pipe, 80mm PP
Spark Generator Support Bracket
Tank Hold-out Bracket, VM110P
O-Ring, Inlet/Outlet, 4 x 17 mm, VM110P
Retaining Clips, Inlet/Outlet, VM110P
CH Fittings, IWC, ¾” NPT, VM110P
Rocker Power Switch, On/Off
CPVC Pipe 3”, System 636, 5” Long
Pressure Relief Valve, ASME, ¾” NPT, 30 PSI (Boiler)
Pressure Gauge, Back Mount, 60 PSI
Round Mesh Vent Screen, 3”
Natural Gas to LP Conversion Instructions
Temp. & Pressure Relief Valve, 150 PSI, ¾”, 100XL-8, VM110P
Compression Gasket, Rubber, VM110P
Low Loss Header Pipe, VM110P
IWC – Integrated Water Control, Vmax Plus, VM110P
To Next Page
Loading...
