Numatic TTB 1840 - Coshh; Control of Substances Hazardous to; Water Flow Adjustment; Pre-Cleaning Advice

26
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specication.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit http://www.hse.gov.uk/ for UK information.
Water Flow Adjustment
Located on the left of the machine is the On / Off water tap (Fig.14).
Ideally set the tap to 45
0
this enables the cleaning solution to last the same
time as a fully-charged battery (Fig.15).
Pre-cleaning advice
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the oor
(Fig.16).
Numatic part (629044) Wet Floor sign
(available if required)
45
0
Machine Set-Up
WHEN HANDLING AND MIXING CHEMICALS
Always ensure that chemical manufacturer’s safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
!
!
IMPORTANT
Do not operate machine unless the Operator Manual has been read and fully understood.
!!
14
15
16