Numatic TTB 1840 - Regular Maintenance; Cleaning tanks and filters

34
After use, empty waste-water tank using
emptying hose and ush-out with clean water.
A
Remove the two hoses to disconnect the separator from the machine
(Fig.28).
Lift off the separator. The separator has a sealing-rubber which should
be examined at every clean-down (Fig.29).
Rinse using clean water.
NOTE:
Avoid over tightening the clean water draining cap.
The TTB 1840 has been designed with ease of use in mind, this included easy stripping-down and cleaning.
Remove the two lters clipped into the separator and ush with clean water (Fig.30)(Fig.30a).
Replace by tting the rear of the lter rst then clipping the front to lock in place (Fig.31) (Fig.32).
Disconnect and remove the battery
before proceeding with tank removal
(Fig.33).
Once emptied the top waste-water tank
can simply be lifted off. (Fig.33a).
The clean-water tank can be drained via the yellow cap tted to the left hand
side of the machine. The cap has a rubber seal and might require a spanner to
remove (Fig.34).
A
Regular Maintenance
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
! !
28
29
30
31
32
30a
33
33a
34