Jetson Orin Module Boot Considerations
PRELIMINARY INFORMATION
Jetson Orin NX Series and Jetson Orin Nano Series DG-10931-001_v1.1 | 10
No other signals are required or supported for entering Force Recovery mode. Neither VBus
or USB ID detection is needed. If the force recovery strap is held low coming out of reset,
Jetson Orin module will configure USB0 as a device and enter recovery mode.
See the USB section (Section 0) for an example figure that shows USB0 connected to a USB
Micro B connector.
To Next Page
Loading...
