Nvidia Jetson Orin NX Series User Manual

General Routing Guidelines
PRELIMINARY INFORMATION
Jetson Orin NX Series and Jetson Orin Nano Series DG-10931-001_v1.1 | 84
17.5 Common High-Speed Interface
Requirements
The following table describes the common high-speed interface requirements.
Table 17-2. Common High-Speed Interface Requirements
Parameter
Requirement
Units
Notes
Common-mode Choke (Not recommended only used if absolutely required for EMI issues)
Preferred device
Type: TDK ACM2012D-900-2P. Only if
needed. Place near connector. Refer to
Common Mode Choke Requirement
section.
Location - Max distance from to adjacent
discontinuities ex, connector, AC cap)
8 (53)
mm (ps)
TDK ACM2012D-900-2P
See Figure 17-2
@TR-200ps (10%-90%)
Common-mode impedance @ 100MHz Min/Max
65/90
Max Rdc
0.3
Differential TDR impedance
90
Min Sdd21 @ 2.5GHz
2.22
dB
Max Scc21 @ 2.5GHz
19.2
dB
Serpentine
Min bend angle
135
S1 must be taken care to consider Xtalk
to adjacent pair. See USB 3.2 Guideline
in Figure 17-3.
Dimension Min A Spacing
Min B, C Length
Min Jog Width
4x
1.5x
3x
Trace width
General
Routing over Voids
Routing over voids not allowed except void around device ball/pin the signal
is routed to.
Noise Coupling
Keep critical high-speed traces away from other signal traces or unrelated
power traces and areas or power supply components
The following figures show the common high-speed interface signal routing requirements.
Figure 17-2. Common Mode Choke

Nvidia Jetson Orin NX Series Specifications

General

Networking	Gigabit Ethernet
Module Size	69.6 mm x 45 mm
Operating System	Linux (JetPack SDK)
GPU	NVIDIA Ampere architecture with 1024 CUDA cores
CPU	8-core ARM Cortex-A78AE v8.2 64-bit CPU
Memory	16GB 128-bit LPDDR5
Storage	eMMC 5.1
AI Performance	100 TOPS (INT8)
Camera	Up to 6 cameras (24 via virtual channels) CSI camera
Power	15W to 25W
Video Encode	1x 4Kp60 | 2x 4Kp30 | 4x 1080p60
Connectivity	PCIe Gen4
Other I/O	GPIO, I2C, SPI, UART, CAN