Nvidia Jetson Orin NX Series - Module Installation and Removal; Figure 5-1. Jetson Orin Module Installed in SODIMM Connector; Figure 5-2. Module to Connector Assembly Diagram

Modular Connector
PRELIMINARY INFORMATION
Jetson Orin NX Series and Jetson Orin Nano Series DG-10931-001_v1.1 | 14
Figure 5-1. Jetson Orin Module Installed in SODIMM Connector
Standoffs
SO-DIMM
Connector
Jetson Orin
NX Module
Mounting Screws
5.3 Module Installation and Removal
To install the Jetson Orin module correctly, follow the sequence and mounting hardware
instructions:
Here are some suggested assembly guidelines.
1. Assemble any required thermal solution on the module.
2. Install the module
a). Start with baseboard that has suitable standoff to match SODIMM connector height.
b). Insert module fully at an angle of 25-35 degree into the SODIMM connector.
c). Arc down the module board until the SODIMM connector latch engages.
d). Secure the module to the baseboard with screws into the standoff or spacer (shown in
Figure 5-2).
Figure 5-2. Module to Connector Assembly Diagram
Standoff
Mounting Screw
To remove the module correctly, follow the installation sequence in reverse.