Nvidia Jetson Orin NX Series User Manual

General Routing Guidelines
PRELIMINARY INFORMATION
Jetson Orin NX Series and Jetson Orin Nano Series DG-10931-001_v1.1 | 85
Figure 17-3. Serpentine
17.6 Test Points for High-Speed Interfaces
Ideally, test points are not preferred on very high-speed interface traces as they can degrade
signal integrity. However, to be able to do compliance testing, or interface tuning where
applicable, it may be necessary to include test points at least for early revisions of a design.
The test points are generally required near the receiver. If a connector or some other device
(capacitor, resistor, and so on) exists near the receiver, the pins can be used as test points
without creating additional signal degradation. Where connector or discrete device pins are
not accessible near the receiver end of an interface, it may be necessary to include test points.
When test points are needed for very high-speed interface signals, follow these
recommendations:
 Test points should be very small (less than 0.5 mm).
 Test points should be located on the existing trace (no stub).
 If the test points are placed on differential signals, they should be symmetric for each P
and N signal.

Nvidia Jetson Orin NX Series Specifications

General

Networking	Gigabit Ethernet
Module Size	69.6 mm x 45 mm
Operating System	Linux (JetPack SDK)
GPU	NVIDIA Ampere architecture with 1024 CUDA cores
CPU	8-core ARM Cortex-A78AE v8.2 64-bit CPU
Memory	16GB 128-bit LPDDR5
Storage	eMMC 5.1
AI Performance	100 TOPS (INT8)
Camera	Up to 6 cameras (24 via virtual channels) CSI camera
Power	15W to 25W
Video Encode	1x 4Kp60 | 2x 4Kp30 | 4x 1080p60
Connectivity	PCIe Gen4
Other I/O	GPIO, I2C, SPI, UART, CAN