NXP Semiconductors
UM12036
MCX-N9XX-EVK Board User Manual
Figure 24. M.2 interface circuit
Note:
•
Many of these connections are not the default connections and are shared with other features of the MCX-
N9XX-EVK. Be sure to check that the signals you intend to use are properly connected to the M.2 connector
circuit and do not overlap with other desired peripherals.
•
Ports P2 and P4 must be configured for 1.8 V operation to use this card connector.
Table 21 describes the pinout of the M.2 connector (J12).
Pin number Net name GPIO Potential conflict
1 GND - -
2 3V3 - -
3 USB D+ - -
4 3V3 - -
5 USB D- - -
6 LED1 - -
7 GND - -
8 I2S_SCK P3_14 • Flash Daughter card connector (J9 pin 25)
Table 21. M.2 connector (J12) pinout
UM12036 All information provided in this document is subject to legal disclaimers. © 2024 NXP B.V. All rights reserved.
User manual Rev. 1 — 20 January 2024
32 / 51
To Next Page
Loading...
