NXP Semiconductors MPC57 Series - 2.4 Hello World Example

Model Based Design Toolbox MPC57xx Series
Quick Start Guide
2-17
2.4 Hello World Example
If the hardware and BootLoader setup is completed successful and a virtual COM port is created
and visible in Control Panel -> Device Manager -> Port (COM & LPT), then
all requirements for running a Model-Based Design Toolbox for MPC57xx Examples are
fulfilled.
Open the Examples Library and go to Communications block and double click on UART Hello
World.
The Simulink uart_hello_world_mpc574xP.mdl model will open. This model
programs the MPC5744P MCU to sent a message over the UART.