Configuration
S32R274/372 EVB User Guide, Rev. 0, 08/2018
NXP Semiconductors 11
Table 5. LIN control jumpers
3.5. FlexRAY configuration
The EVB is fitted with two FlexRAY transceivers, a female DB9 connector (for both transceivers) and
two alternative connectors. Jumpers J27 and J30 are provided to route the respective MCU signals to the
physical interfaces.
The pin-out of the DB9 connector (J2) is shown in the figure below.
Figure 10. FlexRAY DB9 connector pinout
For flexibility, the FlexRAY transceiver is also connected to two FlexRAY connectors (P1 & P2) and
two 2pin Molex connectors (J1 & J3, not populated by default) at the top side of the EVB. Figure 11
shows the connections for both types of connectors.
Figure 11. FlexRAY alternative connector pin-outs
To Next Page
Loading...
