Default jumper summary table
S32R274/372 EVB User Guide, Rev. 0, 08/2018
NXP Semiconductors 35
Some of the port pins of the MCU have dedicated functionality or require short trace lengths to improve
signal intgrity . Therefore these signal have been routed to jumper or connectors on the daughter card.
1. JTAG - (J24)
2. Nexus Aurora – (J23)
3. SIPI – (J17)
4. Sigma Delta ADC – (J16)
5. DAC – (J18)
6. CTE – (J13)
7. MIPI-CSI2 – (J15)
8. RGMII – (U8) (Gb Ethernet Physical Layer)
6. Default jumper summary table
The details for the DEFAULT jumper configuration of the EVB as set up on delivery can be found in
Table 12 and Table 13 depending on the required regulation mode.
6.1. Default jumper table - motherboard
On delivery the motherboard comes with a default jumper configuration. Table 15 lists and describes
briefly the jumpers on the MPC57xx motherboard and indicates which jumpers are on/off on delivery of
the board.
Table 15. Default jumper table - motherboard
To Next Page
Loading...
