Nytech ND-4020 User Manual

E
49
To Delete All Images/Video Clips
1. Turn the camera on by sliding the POWER switch.
2. Press the
button on the rear side of the camera to see
the captured images and video clips.
3. Then press the
button.
4. Select Delete by using the
/ button.
5. Press the OK button and then select [All images on card] by
using the / button.
6. Press the OK button again to confirm.
After that, [No image] pops up. To exit the screen, press
the
playback button, menu button, or rotate the
mode dial. The camera is ready to take the next image
now or video clip.
To delete the images or video clips stored in the internal memory, the steps are the same as mentioned above.Be sure
to remove the SD memory card first and the OSD screen will display as "All images on memory".
The OSD message for deleting all images or video clips will display as “All images on card “or “All images on memory”
base on your decision whether to delete information recorded in the card or in the internal memory.

Nytech ND-4020 Specifications

General

Brand	Nytech
Model	ND-4020
Category	Digital Camera
Language	English