Instruction Manual PCD 650
92
This page allows you to set operating parameters for resistivity measurement
mode. The Pure water coeff, Lnr Temp Coefficient, normalization temperature, cell
constant, calibration due, calibration points are set the same way as previously
described in Conductivity set up. See ‘Conductivity Settings – Page 1’ on page 86.
4.9 Resistivity Setup
Resistivity setup screen present many options to control the operating parameters,
which can be controlled and set from the resistivity setup screen. The settings are
displayed in 2 pages. Press NEXT-P (F2) and PREV-P (F1) to navigate through
these pages.
4.9.1 Resistivity Settings – Page 1
Figure 84: Resistivity Settings - Page 1
4.9.2 Resistivity Settings – Page 2
Figure 85: Resistivity Settings - Page 2
To Next Page
Loading...
