Instruction Manual PCD 650
74
4.1.3 Modifying Setup parameters
Follow the steps below to modify setup parameters, when you enter a setup
sub-group.
1. Press NEXT (F3) key to select individual setup parameters sequentially.
2. Press
(Up) or (Down) arrow key to change the value of a selected
parameter.
3. Once you changed a value:
• Press ENTER key to save the change, or
• Press NEXT (F3) key to go to the next parameter without saving the
changed parameter.
4. Press NEXT-P (F2) or PRE-P (F1) to navigate to next or previous page.
5. Press ESC (F4) to exit from setup mode.
Function Keys available in setup sub-group screens:
PRE-P (F1)
Goes to the previous page of the same sub-group
NEXT-P (F2)
Goes to the next page of the same sub-group
NEXT (F3)
Goes to the next parameter of the same sub-group
ESC (F4)
Goes to measurement mode
Modify the selected parameter value
ENTER
Confirms/saves the changes made to the currently selected parameter
and then goes to the next parameter of the same sub-group
(Not functional)
To Next Page
Loading...
