Instruction Manual PCD 650
52
3.4.1 mV Calibration Report
Calibration report gives you information on calibration. It includes date & time
on which the last calibration was done and the offset.
To View calibration Report:
1. From mV measurement mode, press left or right arrow key to navigate
to other available functions until you see REPO function in the LCD
2. Press REPO (F2) key. The calibration report is shown in the display
[(Figure 45 (b)].
3. Press PRIN (F2) to transfer the calibration report to the computer.( Refer
page 37 to print data)
Note: The function of the keys available on the mV calibration/ report
screen is same as previously described in pH calibration with a user-
defined buffer section (page 48).
To Next Page
Loading...
