Instruction Manual PCD 650
14
Notes:
The communication between CyberComm and the meter is uni-
directional. The connection is initiated by the meter when you press
PRIN key. Once CyberComm finds the meter, press Connect button.
Once the connection is established the data is transferred to
CyberComm and then the IrDA link is disconnected automatically. IrDA
link is disconnected after sending single set of data only if ‘SINGLE’ is
selected from System Setup (page 78).
To re-establish the connection, you need press PRIN key of the
meter followed by Connect button from CyberComm.
For continuous transfer of measurement readings, set CURRENT DATA
SET
parameter to ‘TIMED’ in System Setup (page 78).
For single transfer of measurement reading, set CURRENT DATA SET
parameter to ‘SINGLE’ in System Setup (page 78)
To Next Page
Loading...
