Oceanic Pro Plus - NO DECOMPRESSION DIVE MODE

37
Datamax Pro Plus
Depth and Time displays will not appear until the O2 bar graph recedes into
the green (normal) zone (e.g., your daily oxygen dosage decreases an amount
equivalent to the amount accumulated during the latest dive completed).
NO DECOMPRESSION DIVE MODE
As long as it is activated on the surface, the Pro Plus will enter the No Decom-
pression Dive Mode when you descend deeper than 5 feet (1.5 meters), regard-
less of the operating mode it is in. If activated below 4 feet (1 meter), the unit
will perform a diagnostic check and shutdown.
To activate the Oceanglo
®
backlight underwater, press the Select (Right) but-
ton. The display will be illuminated for button depression time plus 5 seconds.
It will not activate if a Low Battery condition exists.
Main Display (data shown depends on Alternate ON/OFF setting)
If the Alternate Display is set to 'OFF', information (Fig. 38) includes -
Current Depth, Elapsed Dive Time (and icon), Dive Time Remaining (and
icon), Maximum Depth for that dive (and icon), and tank Pressure.
If the Alternate Display is set to 'ON', information (Fig. 39) includes:
Current Depth, Dive Time Remaining (and icon), and Pressure. Elapsed Dive
Time and Maximum Depth are 'accessed' in Large Format, as described next.
Fig. 38 - Main Display
(Alternate Off)
200 5 10 30 40 50 60
NO DECO
C Z
DECO
C Z O
2
PSI
FT
FT
MAX
Fig. 39 - Main Display (Alt On)
200 5 10 30 40 50 60
NO DECO
C Z
DECO
C Z O
2
PSI
FT