OCULUS Pentacam User Manual

7 Patient Data Management
8 / 29 Instruction Manual Pentacam® / Pentacam HR® (G/70700/0109/en)
6.3 Switching the Pentacam off
Î Close the Pentacam program and Patient Data Management.
Î Shut down the Windows operating system.
Î Switch off the Pentacam at the power supply.
7 Patient Data Management
7.1 Starting Patient Data Management
After you have switched on the PC, it first loads the operating system. It then displays the
user interface for "Patient Data Management".
Fig. 7-1: Patient Data Management
Î To enter the Pentacam program, you must either enter a new patient (8) into the
"Patient" group box or select an existing patient (2) from the list.
1 "Functions" group box 5 [Import] button
2 Previous examinations 6 [Delete Patient] button
3 [Delete exam.] button 7 Patient list
4 [Export] button 8 "Patient" group box

OCULUS Pentacam Specifications

General

Measurement Time	Less than 2 seconds
Corneal Coverage	Up to 12 mm
Software	Pentacam Software
Data Transfer	USB
Corneal Topography	Yes
Display	External monitor required
Measurement Principle	Scheimpflug imaging
Camera	Rotating Scheimpflug camera
Light Source	Blue LED
Pachymetry	Yes
Anterior Chamber Analysis	Yes
Imaging Principle	Scheimpflug imaging
Fixation	Internal
Power Supply	100-240 V, 50/60 Hz
Resolution	High resolution
Lens Density Measurement	Yes
Dimensions	Varies depending on model and configuration
Weight	Varies by model, check manufacturer specifications
Number of Images	25 or 50