OHAUS MB90 - Target Weight Setting

EN-36 MB90
%MC(Moisture Content) = Initial weight-Final weight x 100%
Initial weight
%DC(Solids Content) = Final weight x100%
Initial weight
%RG(Regain Content) = Initial weight-Final weight x 100%
Final weight
7.7 Target Weight
Target weight is used when previous samples have been tested and the target weight is known. A
consistent sample size is required when using Target Weight. If the target weight is out of tolerance,
the measurement cannot be started.
Select the Target Weight.
Enable the Target weight and press ON
button.
Set the target weight and press OK button.
Press Target weight tolerance to set the
tolerance of target weight.
Set the target weight tolerance in %.