EN-50 MB90
11.5 Service information
If the Troubleshooting section does not resolve or describe your problem, you will need to
contact an authorized Ohaus Service Agent. For Service assistance in the United States,
please call Aftermarket, Ohaus Corporation. An Ohaus Product Service Specialist will be
available to help you.
11.6 Accessories
Description Ohaus Part No.
Reusable Sample Pan 80252478
Security Locking Cable 80850043
Printer SF40A 30045641
Sample Pans 90mm diameter 80850086
Glass Fiber Pads 80850087
In-use Cover 30284478
Temperature Calibration Kit 11113857
12. TECHNICAL DATA
12.1 Admissible ambient conditions
Indoor use only
Altitude: Up to 4000m
Temperature range: 10 ºC to 40 ºC
Atmospheric humidity: Maximum relative humidity 80% for temperatures up to 31 °C
decreasing linearly to 50% relative humidity at 40 °C.
Warm-up time: At least 30 minutes after connecting the instrument to the
power supply; when switched on from standby-mode, the
instrument is ready for operation immediately.
Voltage fluctuations: Mains supply voltage fluctuations up to ±10% of the nominal
voltage
Over voltage category: II
Pollution degree: 2
Power load: Max. 450 W during drying process
Power supply voltage: 100 V – 90 VAC 5A 50/60 Hz or
200 V – 240 VAC 2.5A 50/60 Hz
(depending on the model)
Power line fuse: 6.3A 250VAC for 100-120VAC power supply or
2.5A 250VAC for 200-240VAC power supply according
to the heating element
To Next Page
Loading...
