- 81 -
Printing Data on a USB Memory Device
3
Printing
Changing the Number of Copies
(Copies)
You can set the number of copies to be printed.
1 Press the scroll button to select [Print
Setup
] then press the <ENTER> button.
2 Press the scroll button to select
[Copies] then press the <ENTER>
button.
3 Enter the number of copies then press
the <ENTER> button.
You can assign up to 999.
4 Press the <BACK> button to return to
the Start screen.
Memo
● The selectable trays are as follows:
- Tray 1 (Factory default setting)
- Trays 2–4 (when additional trays are installed)
- MP Tray
Duplex Printing (Duplex)
You can select either single-sided or duplex
printing.
Note
● For printing of a PRN le, single-sided/duplex printing
designated in the printer driver when the le to be printed
was created will be selected.
1 Press the scroll button to select [Print
Setup] then press the <ENTER> button.
2 Press the scroll button to select
[Duplex] then press the <ENTER>
button.
3 Press the scroll button and select [On]
for duplex printing or [Off] for single-
sided printing, then press the <ENTER>
button.
4 Press the <BACK> button to return to
the Start screen.
Binding Setting (Binding)
The binding position can be set for duplex
printing.
1 Press the scroll button to select [Print
Setup] then press the <ENTER> button.
2 Press the scroll button to select
[Binding] then press the <ENTER>
button.
3 Press the scroll button to select [Long
Edge] or [Short Edge], then press the
<ENTER> button.
4 Press the <BACK> button to return to
the Start screen.
Fitting the Page Size into the Paper
Size (Fitting)
You can t the page size into the paper size and
print.
If the page size of a le to be printed is too large
or small for the effective printing area of the
paper, tting will be automatically performed to
t the page size into the paper size.
Note
● This setting will not be available for printing of a PRN le.
Memo
● The default setting of this function is [On].
1 Press the scroll button to select [Print
Setup] then press the <ENTER> button.
2 Press the scroll button to select [Fit]
then press the <ENTER> button.
3 Press the scroll button and select [On]
to enable the tting function and [Off]
to disable it, then press the <ENTER>
button.
4 Press the <BACK> button to return to
the Start screen.