C3600n User’s Guide
105
• To remove a sheet just entering the fuser, separate the trailing
edge of the sheet from the belt, push the fuser pressure
release lever (1) towards the front and down to release the
fuser’s grip on the sheet, and withdraw the sheet through the
drum cavity area. Then allow the pressure release lever to rise
again.
9. Starting with the cyan image drum unit nearest the fuser, replace
the four image drums into the drum cavity, making sure to locate
them in the correct order.
ID Positions_Fig1_0
NOTE
If the sheet is well advanced into the fuser (only a short
length is still visible), do not attempt to pull it back. Follow the
next step to remove it from the rear of the printer.
1. Cyan cartridge 2. Magenta cartridge
3. Yellow cartridge 4. Black cartridge
1
1
2
3
4
To Next Page
Loading...
