C5550 MFP User’s Guide
Configuring your machine > 53
System configuration menu
ITEM CHOICE DESCRIPTION
Pow Save Time
5
15
30
60
240
Adjusts the idling time before the
printer automatically switches into
power saving mode. In this mode
power consumption is reduced to a low
level required to just keep the printer
operating and ready to receive data.
When a job is sent the MFP will require
a warm-up time of up to 1 minute
before printing can begin.
Personality
AUTO
EMULATION
PCL
IBM PPR III XL
EPSON FX
PS3
EMULATION
This item selects which industry
standard emulation your MFP should
use. When set to AUTO, incoming data
is examined and the correct emulation
is automatically selected each time a
print job is received.
USB PS Protocol
RAW
ASCII
Selects PostScript data format for USB
port.
Clrable Warning
ONLINE
JOB
When ONLINE, non-critical warnings,
such as requests for a different paper
size, can be cleared by pressing the ON
LINE button. When set to JOB, they are
cleared when the print job resumes.
Auto Continue ON/OFF
Determines whether or not the MFP will
automatically recover from a memory
overflow condition.
Manual Timeout
OFF
30 sec
60 sec
Specifies how many seconds the MFP
will wait for paper to be fed before
cancelling the job.
Wait Timeout
5~40~300
OFF
Specifies how many seconds the MFP
will wait when received data pauses
before forcing a page eject. In
PostScript Emulation mode the job will
be cancelled if timeout occurs.
Low Toner
CONTINUE
STOP
Specifies whether the MFP should
continue printing even after a low toner
condition is detected.
Jam Recovery ON/OFF
Specifies whether the MFP should
perform jam recovery after a paper jam
has occurred. If ON, the MFP will
attempt to print again any pages lost
due to a paper jam once the jam has
been cleared.
To Next Page
Loading...
