沖データ企業秘密・OkiDataCONFIDENTIAL
45530603TX −107／130
Priority
Status Message Ready
LED
Atten
LED
Function Status level
Error code
Status code
260 1
2
3
□
File System Operation failed <nnn>
Press OK Button
Varies
On A disk error is occurred, which is other than the file system fill or the disk write protected.
Operation that does not involve a disk is available. nnn: An identifier to Error type (For
details, see the overview chapter.)
%FS_ERR%
= 0 … GENERAL ERROR
= 1 … VOLUME NOT AVAILABLE
= 3 … FILE NOT FOUND
= 4 … NO FREE FILE DESCRIPTORS
= 5 … INVALID NUMBER OF BYTES
= 6 … FILE ALREADY EXISTS
= 7 … ILLEGAL NAME
= 8 … CANT DEL ROOT
= 9 … NOT FILE
= 10 … NOT DIRECTORY
= 11 … NOT SAME VOLUME
= 12 … READ ONLY
= 13 … ROOT DIR FULL
= 14 … DIR NOT EMPTY
= 15 … BAD DISK
= 16 … NO LABEL
= 17 … INVALID PARAMETER
= 18 … NO CONTIG SPACE
= 19 … CANT CHANGE ROOT
= 20 … FD OBSOLETE
= 21 … DELETED
= 22 … NO BLOCK DEVICE
= 23 … BAD SEEK
= 24 … INTERNAL ERROR
= 25 … WRITE ONLY
Warning
32000
~
32026
261 1
2
3
□
Invalid Secure Data
Press OK Button
Varies
Varies
Indicates that a job has been deleted because corruption of data has been detected by the
integrity verification in authentication printing.
Warning
30963
262 1
2
3
□
Invalid Data
Press OK Button
Varies
Varies
Invalid data was received. Press the On-line switch and eliminate the warning. Displayed
when unsupported PDL command is received or a spool command is received without
HDD.
* Except GDI printer
Warning
30114
263 1
2
3
□
Accounting Log Writing Error
Press OK Button
Varies
Varies
Indicates that writing of a job account log has failed due to a disk access error during
writing of the log (related to logging).
This status remains displayed until the OK button is pressed.
Warning
10815
264 1
2
3
□
IPv4 Address is conflicted
Change IPv4 Address
Varies
Varies
IPv4 address conflicts with other apparatus. Warning
10651
300 1
2
3
Install %MEDIA_SIZE% in MPTray
Press OK Button
On Off Manual paper feed is required. Manually insert the paper shown by %MEDIA_SIZE%.
The unit of paper size in Custom: The unit specified for MPTray (menu setting) is used if no
unit is specified by the driver. When the driver specifies a unit, the unit is used for display.
Paper size displays in Custom mode: "<width>x<length> <unit>"
ex.) 210x297 mm
8.5x11.0 inch
The unit of paper size in Custom: The unit specified for MPTray (menu setting) is used if no
Error
(ONLINE)
411yy
yy: paper size
To Next Page
Loading...
