沖データ企業秘密・OkiDataCONFIDENTIAL
45530603TX −94／130
Appendix-A LCD/LED DISPLAYS
LCD/LED Display Method
The following shows the basic display method of LCD.
LCD notifies an operator status, error codes and accompanying information by messages. LCD has two
line display area. The upper line shows status and operation method. The lower line shows error codes,
status, warning and accompanying information for operation. When multiple errors are occurring, all the
errors appear in toggle.
Normal Status
This is normal operation status such as on-line or processing. Accompanying information is shown
in lower line in case of copy mode printing or etc.
Warning Status
This is warning status in which operation can continue. If a user continues the operation, an error
might occur. This warns a user.
Error Status
Operation cannot continue. An operator has to implement an appropriate treatment and recover
from the error.
According to an error type, a 3-digit number is given as an error code. Fatal error means an
irrecoverable error that requires a service call.
LCD/LED Display List
The following table shows a list of status messages and alarm messages (LCD, LED displays).
The priorities in the message are listed from low priority to high priority.
When more than two messages are active, a message with higher priority is displayed. Or two (or
more) messages are alternately displayed.
The meaning of the LCD displays is as follows.
%TRAY% ：Trays (TRAY1,TRAY2,MPTRAY)
%MEDIA_SIZE% ：Paper Size (LEETER,A4 SIZE, . . . . . ,B5 SIZE,A6 SIZE)
%MEDIA_TYPE% ：Meida type(Plain, Transparency, …)
%COLOR% ：Toner for each color (Y,M,C,K)
The meaning of the LED lamp displays is as follows.
ON : On status,
OFF : Regardless of the previous status, OFF,
Blink : Repeats ON/OFF at a certain interval
Varies :Depends on other status (Corresponding message does not change the
status.)
To Next Page
Loading...
Need help?
General
