沖データ企業秘密・OkiDataCONFIDENTIAL
45530603TX −115／130
Priority
Status Message Ready
LED
Atten
LED
Function Status level
Error code
Status code
3
Please see HELP for details Error 639 : J2: Paper Exit Path 639 40885
339.5
1
2
3
Check Duplex Unit
Paper Remain
Please see HELP for details
Off Blink
Additional paper is detected when a paper jam has occurred.
Error 640 : J4: Duplex Entry Path
Error 641 : J5: Duplex Reversal Path
Error 642 : J3: Duplex Transport Path
Error
640
641
642
40886
40887
40888
340 1
2
3
Check the lower side of Duplex Unit
Paper Remain
Please see HELP for details
Off Blink
Indicates detection of paper remaining in the spot color overprint path.
Error 650：Multi Path Jam
Error
650
40392
341 1
2
3
Check Face Down Stacker
Paper Remain
Please see HELP for details
Off Blink
Indicates detection of paper remaining between the fuser unit and the Face Down stacker.
Error 651：Paper Face Down
Error
651
40391
347 1
2
3
Image Drum Sensor Error
Please check %COLOR% image drum and reset.
Please see HELP for details
Off Blink
Something is wrong with the toner sensor.
This status is indicated in Shipping Mode only.
If the same error is detected in FACTORY Mode, it is indicated as service call of 163.
Error 5400 : Yellow
Error 5401 : Magenta
Error 5402 : Cyan
Error 5403 : Black
Error 5404 : White
Error 5405 : Clear
Error
5400
5401
5402
5403
5404
5405
40960 (Y)
40961 (M)
40962 (C)
40959 (K)
40451 (W)
40452 (L)
348 1
2
3
Check Paper in %TRAY%
Paper Thick Error
Please see HELP for details
Off Blink
Anomalies with Media Weight Detection sensor.
Error 323 : A sensor output with no paper measured is outside the spec.
Error 324: Sensor output value exceeding the upper limit.
Error 325: Paper thickness difference of 50µm in the same tray.
Error 326: Different type of paper in the same tray.
(Displayed in Shipping/Factory Mode.)
Error
323
324
325
326
40973
348.5
1
2
3
PU Error <n> Off Blink
Notifies an uncontrollable PU error.
Upon reception of this command, CU stops operating showing an error message with a
sub-number of informed ERRCODE.
This error is recovered by opening and closing the cover.
n: Error code from 1 to 99, 0: Reserved
Error
329
40979
349 1
2
3
Check Paper in %TRAY%
Paper Multi Feed
Please see HELP for details
Off Blink
Warns that inappropriate long paper has been fed from the tray. Check whether
Multi-feed has happened. Recovery Print takes place at Cover Open/Close, allowing the
operation to continue.
Error
401
30089
350 1
2
3
Check Paper in %TRAY%
Paper Size Error
Please see HELP for details
Off Blink
Inappropriate size paper was fed from a tray. Check the paper in the tray or check for
Multiple-feed. Open and close the cover to perform recovery printing, and continue.
In this state, Leisus I/F : OPJAM bit #7 should be '0'.
Error
400
30034
353 1
2
3
Open Right Side Cover
Paper Jam
Please see HELP for details
Off Blink
Paper jam occurred during paper feeding from tray.
Error 390 : MP Tray
Error
390
40077
354 1
2
3
Open %TRAY% Side Cover
Paper Jam
Please see HELP for details
Off Blink
Paper jam occurred during paper feeding from tray.
Error 391 : Tray1
Error 392 : Tray2
Error 393 : Tray3
Error 394 : Tray4
Error 395 : Tray5
Error
391
392
393
394
395
40077
355 1
Open Right Side Cover Off Blink
Jam has occurred in paper path. Error 40982
To Next Page
Loading...
