Graphic pro 49
W
INDOWS
This information applies to the Windows PCL 5c, PCL 6 and
PostScript drivers.
If you are using a source RGB document, simulate the output of
another printer by making the following selections in the printer
driver:
1. On the printer driver [Colour] tab, select [Graphic Pro] (1)
and click [Options].
2. Select [Printer Simulation] (2).
3. Select the ICC profile that corresponds to the device used
to capture or display your source document - this could be
a monitor, scanner or digital camera (3).
Remember that the names “RGB Source 1”, “RGB
Source 2” and so on relate to the number assigned to the
1
2
3
4
5