Oki MB451 - Settings for each Dialing Type

Basic Settings for Faxing (for MB451, MB451w, MB471, MB471w, MB491, ES4191 MFP only)
-43-
Setup
1
Connecting PBX, Home Telephone or
Business Phone
Plug the [Telephone cable] connected to the
[Public Line (Analog)] into the [LINE
connection] of your machine.
Remove the telephone connector cover.
Plug the telephone cable connected to a control
device including PBX, etc. into the [TEL
connection] of your machine.
- Home Telephone -
A number of telephones are connected with one or
two telephone lines to allow internal and door
phone communication. This is simple switching
equipment for household.
- Business Phone -
More than two telephone lines can be
accommodated, and these telephone lines can be
shared with a number of telephones to allow
internal communication. This is simple switching
equipment.
Connecting as an Internal Telephone
Plug the [Telephone cable] connected to a
control device including PBX, etc. into the [LINE
connection] of your machine.
Memo
 Set [PBX Line] to [ON]. Refer to "PBX Connecting" P. 45.
Settings for each dialing type
The factory default [MF (Tone)/DP (Pulse)] is
set to [Tone].
 For push-button phones, if you hear a "Beep, boop,
beep" sound, leave [MF (Tone)/DP (Pulse)] as
[Tone].
 For push-button type phones, if you do not hear a
"Beep, boop, beep" sound, or if you are using a
rotary-dial type phone, set [MF (Tone)/DP
(Pulse)] to [Pulse].
 How to Configure Settings
1
Press the <SETTING> key on the
operator panel.
2 Press the to select [Admin Setup],
and press .
3 Enter the administrator password.
The factory default password is "aaaaaa".
4 Select [Enter], and press .
5 Press the to select [User Install],
and press .
6 Press , select [MF (Tone)/DP
(Pulse)], and then press .
7 Press , select Dial Type, and then press
.
LINE connection
TEL connection
Telephone cable
Public Line
(Analog)
Control device
including PBX,
etc.
LINE connection
Public Line
(Analog)
Telephone cable
Control device
including PBX,
etc.
OK
OK
OK
OK
OK