Connecting to a Computer
-52-
If configuring a small network consisting of only your
machine and a computer, set IP addresses as shown below
(according to RFC1918).
To set [Network Scale], press the <SETTING> key and
then select [Admin Setup] > [Network Menu] >
[Network Setup] > [Network Scale].
First, Set the IP address of the machine.
1 Hold down the power switch for about a
second to turn on the power.
2 Press the <SETTING> key on the
operator panel.
3 Press the to select [Easy Setup], and
press .
4 Enter the administrator password.
The factory default password is "aaaaaa".
5 Select [Complete], and press .
6 Press the and [Network Setting],
and then press the .
7 If setting the IP address manually, check
that [Manual] is selected, and press .
If obtaining the IP address automatically, press
the and select [Auto], and press . Proceed
to step 12.
8 Enter the IP address and press .
To move to the next box, press the .
9 Enter the subnet mask and press .
To move to the next box, press the .
10 Enter the default gateway address and
press .
To move to the next box, press the .
11 Enter the DNS server and WINS server if
needed.
If it is not necessary to connect the DNS server or
WINS server to the network, press until the
pop-up message showing the setting completion is
displayed.
12 When the setup menu screen is
displayed, press to complete the
setup.
For the computer
IP address : 192.168.0.1~254
Subnet mask : 255.255.255.0
Default gateway : not used
DNS server : not used
For the machine
IP address Set : Manual
IP address: 192.168.0.1~254 (select a dif-
ferent value from the com-
puter)
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
Network Scale : Small
OK
OK
OK
OK
To Next Page
Loading...
