44292401TH Rev.1
107 /
Oki Data CONFIDENTIAL
ADJUSTMENT/SETTING
(1) SUBNET MASK
(2) GATEWAY
C. DNS CONFIG.
(1) ENABLE
Function • This function is used to specify the subnet mask value for the network.
NOTE
• Please consult customer’s network administrator for information about the sub-
net mask to use.
Use
Setting/
procedure
• Setting LAN connect to WAN the net mask address.
NOTE
• If Auto is selected for [IP ADDR. SETTING], the items of [SUBNET MASK] and
[GATEWAY] are automatically set. Key entry is therefore disabled for [SUBNET
MASK] and [GATEWAY].
Function • This function is used to specify the default gateway (IP address) of a router on the net-
work.
NOTE
• Please consult customer’s network administrator for information about the gate-
way to use.
Use
Setting/
procedure
• Setting LAN address.
NOTE
• If Auto is selected for [IP ADDR. SETTING], the items of [SUBNET MASK] and
[GATEWAY] are automatically set. Key entry is therefore disabled for [SUBNET
MASK] and [GATEWAY].
Function • Sets whether or not the DNS server setting is to be specified.
• If specifying the DNS server setting, the SMTP server can be specified as a host name
when using network scanning.
• If [ENABLE] is selected, type in the IP address of the DNS server.
• If [DISABLE] is selected, the DNS server cannot be referenced.
Use
Setting/
procedure
• The default setting is DISABLE.
“DISABLE” / ENABLE
Function
• Sets the DNS server address (up to three addresses).
Use
Setting/
procedure
• The default setting is 0.0.0.0.
DNS1 / DNS2 / DNS3
D. DHCP
E. BOOTP
F. ARP/PING
G. HTTP
H. FTP
Function
• Automatically acquires an IP address from the DHCP server, if there is one in the net-
work, and specifies whether to load other network information.
Use • To automatically acquire an IP address and load other network information.
Setting/
procedure
• The default setting is ENABLE.
DISABLE / “ENABLE”
NOTE
• When setting the IP address manually, the [DHCP] setting is changed to [DIS-
ABLE].
Function
• Automatically acquires an IP address from BOOTP and specifies whether to load other
network information.
Use • To automatically acquire an IP address and load other network information.
Setting/
procedure
• The default setting is DISABLE.
“DISABLE” / ENABLE
NOTE
• When setting the IP address manually, the [BOOTP] setting is changed to [DIS-
ABLE].
Function
• Automatically acquires an IP address from ARP/PING and specifies whether to load
other network information.
Use • To automatically acquire an IP address and load other network information.
Setting/
procedure
• The default setting is DISABLE.
“DISABLE” / ENABLE
NOTE
• When setting the IP address manually, the [ARP/PING] setting is changed to [DIS-
ABLE].
Function • Select whether or not to enable HTTP.
Use
• If [ENABLE] is selected, HTTP is enabled.
• If [DISABLE] is selected, HTTP is disabled.
Setting/
procedure
• The default setting is ENABLE.
DISABLE / “ENABLE”
Function • Select whether or not to enable the FTP server.
Use
• If [ENABLE] is selected, FTP server is enabled.
• If [DISABLE] is selected, FTP server is disabled.
Setting/
procedure
• The default setting is ENABLE.
DISABLE / “ENABLE”
To Next Page
Loading...
Need help?
General
