44292401TH Rev.1
114 /
Oki Data CONFIDENTIAL
ADJUSTMENT/SETTING
Function
• This function can be used to set the default setting (ON or OFF) for adding the header
(date sent, sender's name and fax number, etc.) when sending faxes.
Use
Setting/
procedure
• The default setting is ON.
“ON”: Add header
OFF: No header
NOTE
• If [PTT SETTING] in the [USER SETTING] menu is set to U.S.A, CANADA, or
KOREA, this setting cannot be changed.
The contents of registration.
• TX data and time.
• Transmitter’s own name.
• Transmitter’s own tel number.
• Session number.
• Page number.
• Total page number (only displayed by use the memory TX job).
It is selectable by soft switch to transmit only pages which have failed to transmit, if com-
munication error occurs on the way transmitting document. In this case, page number
on Header Print is continued from the page number of the document successfully trans-
mitted. Whether user setting is allowed or not is selectable with Soft switch.
Attaching Header Print:
• Image within 4 mm (1/4 in.) top margin of transmitting document is not transmitted and
Header print data is attached.
12.8 FAX RX OPERATION
12.8.1 MEMORY RX MODE
12.8.2 NO. of RINGS
12.8.3 REDUCTION RX
Function • This function can be used to set whether to allow [ON] memory reception or not [OFF].
In cases when confidential faxes are being received, the received document can be
stored in the memory and printed at a specified time or when memory reception is set to
[OFF]. A password can be set to specify the starting time or ending time of memory
reception, or to cancel the function. The set starting time and ending time are valid every
day until memory reception is turned off.
Use
Setting/
procedure
• The default setting is OFF.
ON: Enable memory RX mode
“OFF”: Disable memory RX mode
Function
• This function can be used to set the number of rings between 1 and 16 until the call is
answered.
Use
Setting/
procedure
• Default: Depends on [PTT SETTING].
• Depend on soft switch setting of marketing area.
NOTE
• When PTT setting is New Zealand, the setting range is 7-10.
1: 1 time “2”: 2 times 3: 3 times 4: 4 times 5: 5 times 6: 6 times
7: 7 times 8: 8 times 9: 9 times 10: 10 times 11: 11 times 12: 12 times
13: 13 times 14: 14 times 15: 15 times 16: 16 times
Function • This function can be used to set whether documents longer than the paper are printed
reduced [ON], split [OFF], or discarded [CUT]. However, when sending a document
more than 24 mm (1 inch) longer than the paper, [CUT] is not available. (In this case, the
document is split.)
Use
Setting/
procedure
• The default setting is ON.
OFF: 100% RX mode
“ON”: Reduction print mode
CUT: Cut mode
11.8.2 NO. of RINGS
11.8.3 REDUCTION RX
11.8 FAX RX OPERATION
11.8.1 MEMORY RX MODE
11.7.4 HEADER
To Next Page
Loading...
Need help?
General
