Oki MC562w Maintenance Manual

44952001TH Rev.2
7-46
Oki Data CONFIDENTIAL
7. TROUBLESHOOTING PROCEDURES
Display Cause Error details Measure
Inspection is
required.
182 : Error
Option unit I/F
error
Doestheerroroccuragain?
Doestheerroroccuragain?
Yes
Yes
Turn off and on the
M F P.
Be sure of connector
connection.
Replace the option
unit.
Power OFF/ON
190 : Error
System
memory
overflow
Doestheerroroccuragain?
Yes
Turn off and on the
M F P.
Replace the CU/PU
board.
Inspection is
required.
200 : Error
～
202 : Error
PU firmware
download error
An error occurred in re-
writing
the PU firmware.
Turn off and on the
MFP, and then re-
download it (In general
use of the MFP, this
re-writing is not
performed and this
error does not occur).
Power OFF/ON
203 : Error
204 : Error
207 : Error
208 : Error
213 : Error
214 : Error
F0C : Error
FFE : Error
FFF : Error
CU program
error (203
to 214 do
not occur in
general use of
the MFP)
Invalid processing was
performed with a CU
program.
Replace the CU/PU
board.
Power OFF/ON
209 : Download
error
Custom
Media
Type table
downloading
failure
Custom Media Type table
downloading failed.
Turn off and on the
MFP, and then re-
download it (In general
use of the MFP, this
downloading is not
performed and this
error does not occur).
Display Cause Error details Measure
Inspection is
required.
231 : Error *
TAG interface
error
IA TAG interface error was
detected.
Be sure the toner
cartridges and the
image drums are
properly set.
Replace the toner
cartridges. When the
error occurs again
after the image drums
are re-installed, be
sure of the cable
connection from the
CU/PU board to the
toner sensor board.
01 : A short-circuit error.
03 : TAG communication
error.
Power OFF/ON
250 : Error
SD card error
Inspection is
required.
251 : Error
SD card
erasure error
Inspection is
required.
252 : Error
～
255 : Error
SD card
security error
Inspection is
required.
256 : Error
257 : Error
SD card error
Power OFF/ON
Error : 802
Error : 803
Error : 805
Error : 807
Error : 808
SU Exception Doestheerroroccuragain? Yes Turn off and on the
M F P.
Replace the SU board.
Power OFF/ON
Error : 809
SU NAND
ECC Error
The ECC error that
restoration was impossible
occurred in NAND FLASH of
SU.
Power OFF/ON
Error : 811
Error : 812
Error : 813
SU Com-
munication
Error
Communication error
between the Controller and
the Scanner Unit is detected.
Turn off and on the
M F P.

Oki MC562w Specifications

General

Brand	Oki
Model	MC562w
Category	All in One Printer
Language	English