Connecting to a computer > 16
I
NTERCONNECTION
1. Ensure that both printer and computer are turned OFF.
2. Connect the required interface cable, USB (1) or parallel (2), or serial or network (3)
to the printer and then to the computer.
3. Turn ON the printer and then turn ON the computer.
E
MULATIONS
The factory default emulation for your printer is IBM PPR.
If you wish to change to one of the Epson or Microline emulations, see “To change a
setting:” on page 41 and “Printer Control” on page 42.
I
NSTALLING
THE
PRINTER
DRIVER
The driver for your printer is provided on the CD included with the printer.
Insert the Drivers CD into your computer and follow the on-screen instructions to install
the printer driver for use with your printer.
P
RINTING
A
TEST
PAGE
As an example, using Windows XP:
1. Use Start > Printers and Faxes to show the Printers and Faxes window.
2. Highlight the driver for your printer.
3. Use File > Properties to show the Properties window.
4. On the General tab, click the Print Test Page button.
5. Ensure that a test page has printed, verifying your printer – computer setup.
NOTE
With the Auto Interface connection enabled, you can also connect all the
interfaces at the same time.
NOTE
If the CD does not AutoPlay, click Start > Run > Browse, then browse to your
CD-ROM drive, double-click Setup.exe and click OK.
1
2
3
To Next Page
Loading...
Need help?
General
