Oki ML6300FB - Page 51

Troubleshooting > 51
The printout differs from the screen display (cont.).
Too large or small
left and/or right
margins.
The left or right
margin is not
correctly selected.
Incorrect positions of
the Paper Guide or Pin
Tractors. Select and
adjust the position
again depending on
the paper type.
Reselect the left and
right margins correctly
in the application.
When continuous
forms are used,
the content of a
single form is
printed on two
forms.
The paper length
selected in the
application does
not match the
physical paper
length.
Match the paper
length selected in the
application with the
physical paper length
in use.
When cut sheets
are used, the
content of a single
sheet is printed on
two sheets.
The paper setting
selected in the
application does
not match the
physical paper
size.
Match the paper
setting selected in the
application with the
physical paper in use.
It does not match
the lines per page
as the printer
automatically
detected.
Leave enough top and
bottom margin in the
application.
Correct the cut sheet
LF adjustment.
The content of a
single line is
printed in two
lines.
The left and/or
right margins are
not correctly
selected.
Reselect the left and
right margins correctly
in the application.
When continuous
forms are used,
several blank lines
appear in the
printout.
Tear-off
perforation
spacing is
selected.
Cancel tear-off
perforation spacing.
Problem Cause Action