Oki ML6300FB - Page 50

Troubleshooting > 50
The printout differs from the screen display.
Printout of
completely
different
characters or
symbols.
Incorrect print
setup for the user
application.
Reselect print setup
for the applications
according to priority.
The application
control codes for
the previous print
operation are still
enabled.
Initialize the printer.
The input
application control
signal is not
correct.
Print in hex dump
mode and verify the
data content. Make
corrections in the
application.
The interface cable
is not properly
connected.
Reconnect the cable
correctly.
Too high or too
low TOF (where
printing starts).
The TOF is not
correctly selected.
Initialize the printer.
Select correct TOF for
cut sheet and
continuous forms.
Select the first-line
print position and
adjust the paper top
position.
Reselect the margin
correctly in the
application.
Problem Cause Action